Fits Standard Faucets Only

Install Your Swaba in Minutes

Remove aerator and slide Mounting Ring over faucet
Remove existing faucet aerator. You may need a small channel lock or pliers for this. Wrap aerator with rag so it does not scuff. Place Swaba mounting ring over end of faucet and slide back out of the way for now. Threaded end facing down.
Select proper Adapter and insert rubber gasket.
Select the correct size adapter and rubber gasket. Fit gasket into adapter. Press gasket into faucet adapter and push evenly around edges so it fits flat. Now you are ready to attach to faucet.
Screw on Adapter and finger tighten to end of the faucet Then snug with Tightening Tool, which is Included
Twist on correct adapter to end of faucet. Be sure to start slow - to be sure threads fit properly. When finger tight - use tightening tool included) to set snug.
Attach Swaba Unit
Attach Swaba Unit: Hold and press unit up on to adapter until seated evenly. Then bring adapter ring down and tighten on to base. Fill with Liquid Dish Soap. Remove Fill Cap and fill soap reservoir until full. Push Fill Cap back into place when done. Refill when necessary.
Watch Installation Video
1. Fill reservoir with liquid dish soap 2. Turn on water to Slow or Medium 3. Turn Handle to Suds or Spray 4. When done - Turn faucet off 5. Refill with dish soap as needed No need to Power-On the Pressure. Low to Medium Pressure is all you need to get the best suds & lather ever!
Copyright © All rights reserved.